Delta bandsaw dust collection fitting

  • Advertise with us
Project by Chris208 posted 247 days ago 1518 views 4 times favorited 3 comments Add to Favorites Watch

In my continuing quest to get my saw dust under control, I built this little fitting. This is based on a tip sent into Fine Woodworking and published in the annual tools and shops edition. This was the simplest dust collection solution I have seen for a bandsaw, and it works great! I notched the elbow so it fit around the guide blocks, and got the suction closer to directly under the table, where all the saw dust comes pouring out.

Total cost was $1.33 for some plumbing parts and hardware from my local Habitat for Humanity Restore. Love that place.

Next up: dust collection for the table saw and router table!

3 comments so far

View rad457's profile


148 posts in 430 days

#1 posted 247 days ago

Hey that looks like my bandsaw, looks like it should work, going to give it a try.

-- Andre of Alberta. Finger Prints show your hands were on the wood.

View clarkey's profile (online now)


443 posts in 1680 days

#2 posted 247 days ago


View woodturner39's profile


22 posts in 1991 days

#3 posted 246 days ago

Good idea.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

Latest Projects | Latest Blog Entries | Latest Forum Topics :: gardening showcase