LumberJocks

Easy-to-Build Bench Dogs

  • Advertise with us
Project by Bricofleur posted 12-15-2013 06:03 PM 2222 views 8 times favorited 3 comments Add to Favorites Watch

These bench dogs were easy and quick to make with the shown maple scrap that I ripped 3/4” square to fit my workbench dog holes. Six inches lengths (providing two dogs) are rounded over at the router table with a 3/8” rounding over bit and then cut at the miter saw. After a quick stop at the disk sander I ended up with nice chamfered ends.

Thanks for looking.

More photos and details on this page of my blog.

Best,

Serge

http://atelierdubricoleur.wordpress.com

-- Learn from yesterday, work today and enjoy success tomorrow. -- http://atelierdubricoleur.wordpress.com





3 comments so far

View Dan Hux's profile

Dan Hux

576 posts in 2070 days


#1 posted 12-16-2013 12:25 AM

Great dogs,, I made mine the same way, I used my lathe instead, turned them just enough to knock off the corners so they would fit the 3/4 in holes I drilled in my bench.

-- Dan Hux,,,,Raleigh, NC http://whitdaniel.com

View majuvla's profile

majuvla

3563 posts in 1563 days


#2 posted 12-16-2013 04:33 AM

What a simple ideas for easy work!

-- Ivan, Croatia, Wooddicted

View Roger's profile

Roger

14898 posts in 1500 days


#3 posted 12-16-2013 12:58 PM

Gr8 idea Serge. Very simple, verfy handy.

-- Roger from KY. Work/Play/Travel Safe. Kentuk55@bellsouth.net

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase