Table Saw Miter Sled

  • Advertise with us
Project by JC_WW posted 11-07-2013 03:17 AM 1675 views 0 times favorited 1 comment Add to Favorites Watch

This is my recently made table saw miter sled. I had some 1/2” plywood scrap so I simply laminated them to three layers…mostly; the top layer was a little small because I miscalculated but it didn’t matter. Then I cut it to a perfect 90 deg on the crosscut sled and screwed it onto my old table saw sled. I cut the corners off so that I could get larger boards on there and it works good so far. I do have to ensure that I cut the angles from both sides because its not perfectly set at 45 deg from the blade. I have a Ryobi table saw and the miter slot is a T-track so I had to cut the runners accordingly. They turned out much better than on my crosscut sled.

-- Justin C.

1 comment so far

View cabmaker's profile


1473 posts in 2230 days

#1 posted 11-07-2013 03:22 AM

Justin looks like it will do a nice job for you and glad to see you set it up to cut that long point first!

Lots of nine fingered people out there that cut the short point first, nice going ! JB

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics