LumberJocks

Table saw/circular saw blade simple storage

  • Advertise with us
Project by tkroupa posted 323 days ago 1195 views 0 times favorited 5 comments Add to Favorites Watch

I have seen a few storage ides for saw blades, and I needed to clean up my shop a little more, so 5 minutes later I had my very simplistic blade storage. I took a scrap 2×6, set my table saw blade to 45 degrees, and started cutting. I made cutes every inch, I guess 1 1/2 inches might have been better. Again nothing fancy but I had a spare side of a storage cabinet, so now it holds my saw blades.

One of these days I will dare to tackle a more complicated and intricate project like the rest of you guys once I get all my shop projects and wife projects done.

-- Tim, Meridian, Idaho https://www.facebook.com/pages/Kroupa-Kustum-Idaho-Wood-Krafts/1429234470652972





5 comments so far

View DwarfsForge's profile

DwarfsForge

6 posts in 336 days


#1 posted 322 days ago

Looks a bit dangerous to me. A heavier hit to the shelf and you’ll have them all on the floor (hopefully not on your foot).

View Johnny Boy's profile

Johnny Boy

65 posts in 1846 days


#2 posted 322 days ago

It has been my first reaction too. Maybe a bit deeper

-- Johnny Boy

View tkroupa's profile

tkroupa

61 posts in 487 days


#3 posted 322 days ago

It seems ok right now. The blades are pretty tight in the grooves, I will do a little testing today. Maybe I will glue another piece of wood on the back of the first one and recut the groove deeper.

Thanks for the advice. Can’t be too safe in the shop.

-- Tim, Meridian, Idaho https://www.facebook.com/pages/Kroupa-Kustum-Idaho-Wood-Krafts/1429234470652972

View ThorinOakenshield's profile

ThorinOakenshield

66 posts in 725 days


#4 posted 322 days ago

I worry about the blades warping from the gravity induced torque. Looks pretty though.

-- -Thorin Oakenshield, King Under the Mountain

View tyvekboy's profile

tyvekboy

533 posts in 1640 days


#5 posted 321 days ago

My suggestion is to add some plywood (minimuum 1/2 inch thick) about 4-5 inches wide and the length of the 2×6 to each side of the 2 X 6 stock and extend the saw cuts and I think it would take the dangerous look out of the storage idea.

-- Tyvekboy -- Marietta, GA

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase