LumberJocks

KREG 2 x 4 Workbench / Outfeed Table

  • Advertise with us
Project by Kerry Drake posted 354 days ago 3592 views 12 times favorited 6 comments Add to Favorites Watch

Using the Kreg plans their 2×4 workbench I modified them slightly to create this Workbench / Outfeed table. I had to shorten the bench to match it to my tablesaw, and actually shortened it quite a bit so I could install some leveling feet to tweek it perfectly for outfeed duties.

I did end up wrapping the edge of the top with some maple I had left over in the shop, and I covered the MDF top with a piece of 1/8 inch hardboard that I simply tacked down with finish nails so I could remove and replace it as needed.

I am impressed with how solid this turned out.

-- Kerry Drake, Loudon NH, http://thenickedfinger.wordpress.com/





6 comments so far

View Todd Swartwood's profile

Todd Swartwood

55 posts in 362 days


#1 posted 354 days ago

Nice job Kerry, I like the way you put a sacrificial top on the bench. it will be very easy to renew the surface as it gets beat up, or covered with glue.
Good job,
Todd

-- Todd Swartwood (Todd Swart-Woodworks)

View MT_Stringer's profile

MT_Stringer

1866 posts in 1868 days


#2 posted 354 days ago

Nice. Almost too nice to use as a work bench. I think that will work great when you use your pocket hole jig. You do have it mounted on a sled, huh? If not, check out mine. Just simple clamp it to that purty new table and gitafterit! :-)

-- Handcrafted by Mike Henderson - Channelview, Texas

View CarterR's profile

CarterR

55 posts in 655 days


#3 posted 354 days ago

That looks great. I am a huge fan of the Kreg jig. I recently built this using the Kreg jig. The table is used to hold tools and wood parts not in use on the workbench. I love that no screws are visible. It is fast and and makes sturdy product.

-- www.lowtideco.com

View Kerry Drake's profile

Kerry Drake

163 posts in 1657 days


#4 posted 354 days ago

MT_Stringer, I almost mounted mine on a board like that, but then it wouldn’t fit inside my Kreg Toolbox.

-- Kerry Drake, Loudon NH, http://thenickedfinger.wordpress.com/

View MT_Stringer's profile

MT_Stringer

1866 posts in 1868 days


#5 posted 354 days ago

Mine hangs on the wall. :-)

-- Handcrafted by Mike Henderson - Channelview, Texas

View David Dean's profile

David Dean

516 posts in 1536 days


#6 posted 354 days ago

nice work drake.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase