|Project by KnotCurser||posted 08-24-2013 09:09 PM||3346 views||10 times favorited||4 comments|
This one started out being a way to use some pallet slats and make a simple six pack carrier.
Then I found a nice strip of walnut in my scrap bin.
Then I used my CNC Router to carve the Hops flowers in each side.
Then I found a scrap of QS Sycamore for the bottom.
Let’s just say it’s no longer “simple” anymore…....... :-)
All mortise and tenon joinery – bottom is set into dadoes for strength.
Top handle uses through tenons.
Yeah – I went a tad overboard on this one. I am pretty sure it will sell though.
Finish is a coat of tung oil and rattle-can lacquer.
-- Robert Rhoades WoodWorks / Email: firstname.lastname@example.org / www.rhoadesclan.com