|Project by steliart||posted 07-25-2013 01:49 PM||2240 views||12 times favorited||19 comments|
My last project with the bookcases renovation was the reason that pushed me to try building a scraper holder.
The design is you will see is very basic, the only difference I made to it was to make round backing wood on the butterfly screw for better support of the blade.
The wood I used was some left over padauk I had which had 4 screw holes on it which I cover with some drywall screws just for decoration.
The backing round wood was attached to the butterfly screw with a t-nut and some epoxy and everything was flash at the front side.
The scraper blade camber is about 3.2 – 3.5mm
Thanks for Watching
-- Stelios L.A. Stavrinides: - I am not so rich to buy cheap tools, but... necessity is the mother of inventions - http://www.steliart.com --