LumberJocks

Stow Away Outfeed Table

  • Advertise with us
Project by cutworm posted 06-22-2013 07:34 PM 1990 views 13 times favorited 6 comments Add to Favorites Watch

I made this last week and am very happy with it. I can set it up in just a few seconds and it folds up for storage in my small garage shop. About the only money invested is for the hardware – hinges, leg levelers and the iron strap for brackets on the table saw. The top locks to the saw with a tongue and groove type of latch for lack of a better word. If I were to do it again I would probably just put a couple of dowels on under side of the melamine and drop the table into holes on the TS.
Thanks for looking.

-- Steve - "Never Give Up"





6 comments so far

View Ken90712's profile

Ken90712

15082 posts in 1875 days


#1 posted 06-22-2013 07:54 PM

Great work, I have the same saw and router table extension. I built a base for it with a drawer as well. I have been wanting to make one of these for a while. Should serve you well. Will have to do this soon, heading to the woodworking show in Vegas next month and looking to buy a 5 hp table saw. Will def make one for the new saw.
Enjoy

-- Ken, "Everyday above ground is a good day!"

View steliart's profile

steliart

1808 posts in 1375 days


#2 posted 06-23-2013 12:11 AM

very practical

-- Stelios L.A. Stavrinides: - I am not so rich to buy cheap tools, but... necessity is the mother of inventions - http://www.steliart.com --

View a1Jim's profile

a1Jim

112299 posts in 2264 days


#3 posted 06-23-2013 12:42 AM

Simple design and very useful,nice work.

-- http://artisticwoodstudio.com Custom furniture

View NiteWalker's profile

NiteWalker

2710 posts in 1263 days


#4 posted 06-23-2013 02:22 AM

Nice job; I really like that design.

-- He who dies with the most tools... dies with the emptiest wallet.

View cutworm's profile

cutworm

1065 posts in 1480 days


#5 posted 06-23-2013 01:18 PM

Thanks guys.

-- Steve - "Never Give Up"

View Grumpymike's profile

Grumpymike

1109 posts in 1002 days


#6 posted 06-23-2013 05:00 PM

I like your out-feed table. Great helper for the 90° cuts, but on my Rigid 2424 at 45° the motor hits the table and I have to pull the table back about a foot from the saw … Oh the challenges we face … but the Grizzly 0715 will cure that.

-- Grumpy old guy, and lookin' good Doin' it. ... Surprise Az.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase