|Project by Chad256||posted 06-12-2013 01:14 PM||759 views||1 time favorited||5 comments|
This is a coin holder that I made for a friend of mine. It is set at a 15 degree angle. The 1/4” dados were cut at the same angle (so they would be vertical) on my table saw and the the coins slightly lean back. Then it was hand sanded to 00 steel wool. It is red oak stained with a dark walnut to contrast the coins. Finished with three coats of spray poly and two coats of paste wax.
Thanks for looking!
-- -- Chad -- T&C Woodworks