|Project by A.Scott||posted 01-08-2013 04:43 PM||2661 views||1 time favorited||4 comments|
Ok here is my first entry and my first project…thanks goes out to Steve Ramsey who inspired me to build this Table Saw Sled.
As you can see I took this while I had the ‘safety box’ clamped. Anyway, I loved the idea of having a stop block to allow me to cut (small) pieces at the same length. So I cut a dado into the 2×4 with my new table saw then I glued a 1/4” thick piece of recycled paneling to it and cut a slot big enough for the bolt to slide through. Now I admit I goofed and realized a little too late that I should have made the dado cut a little deeper and just last night I noticed the 1/4” piece of wood coming loose on the left and right side. I am already planning helping that wood get off the 2×4 and then I will use some scrap 3/8” plywood to replace it.