Table saw moulded picture frame

  • Advertise with us
Project by TVT posted 639 days ago 891 views 1 time favorited 3 comments Add to Favorites Watch

A friend asked me to make this frame for a special picture they had. The overall size is 26”x46”. It came from one piece of 5/4” poplar and I moulded it on my table saw. There is one small detail on the outer edge that I used a router. Picture 2 is a profile view before cutting and glueing. Poplar was chosen because of cost for them and they wanted to paint the frame, although I always prefer stain.

-- Measure once, cut twice - you think I would learn!

3 comments so far

View TexasNick's profile


62 posts in 1101 days

#1 posted 639 days ago

Good job on the Frame. The moulding looks nice, as well. I’ve never tried making moulding on my table saw.

-- Experience: What you have left after you've lost everything else.

View woodchuck82's profile


9 posts in 455 days

#2 posted 382 days ago

very impressive, how did you make the molding on the saw?

View TVT's profile


35 posts in 831 days

#3 posted 380 days ago

Thanks woodchuck. I ran each piece at an angle across the blade by clamping straight edges on both sides of work piece. I then started raising the blade about an 1/16 to 1/8 inch for each pass creating a cove mold. I then cut of one of the edges. Its also a way to make crown molding. Let me know if you have any other questions.

-- Measure once, cut twice - you think I would learn!

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

Latest Projects | Latest Blog Entries | Latest Forum Topics :: gardening showcase