|Project by missingdigitworkshop||posted 09-09-2012 03:15 AM||1110 views||3 times favorited||4 comments|
This is a Cupcake display I just made for a co-worker. Who will be decorating it for her daughter’s birthday party.
It is 16” tall and made from 1/2” MDF.
The bottom tray is 13” with an 11” base glued to it to raise it up.
The middle tray is 10” and the top tray is 7”
The bottom riser is 1 1/2” dowel at 7” and the top is 6”. I drilled the center of the dowel out with a 1/4 bit.
It is all held together with a 5/32 rod with a wooden drawer pull on the top and a T-nut in the base. Due to the length of the rod holding everything together I got a chance to practice threading the rod on both ends.
All the disc were cut on the tablesaw.
-- Do not be discouraged by those who don't. Be inspired by those who do.