|Project by Montezuma45||posted 07-22-2012 05:11 AM||1511 views||1 time favorited||3 comments|
This is the workbench that I’m making for a wedding present. This one isn’t as thick (about 1.25”) and the strips are about 1.66”. It’s slightly over 7’ long.
Okay, I’m almost finished now. The 5 pictures are:
1. The bench top.
2. Pieces I use to lift the bench off the ground. The 2” x 6” is hard to make out but it has two cams drawn out on it for cutting at the band saw. A finished piece is to the right with two cams and a step bar. Below are the two sets for the wheels.
3. Everything is mounted and in the rolling position (when right side up).
4. This is in the solid position (non-moving), notice the position of the wheel setup compared to the clamp.
5. As you can see, there are 3 sections that can have drawers added to this base.