| Project by TripleB | posted 336 days ago | 664 views | 2 times favorited | 3 comments |  |
 |
This is a very simple clock to make on the scroll saw, it’s alway nice to get a project done in a couple hours start to finish. The pattern for this clock came from Steve Good’s site and can be found HERE I obviously made some changes to the pattern that made it simpler and I think a little bit of a cleaner look. I made this from 3/4” Walnut and instead of making a separate base, just used the piece cut out of the middle. For being such a simple piece, I get alot of good comments on it.
Bob
TripleB
Scroll Saw Forum
-- Join me at http://www.scroll-saw-forum.com/
| Pin It |
3 comments so far
Ken90712
home | projects | blog
12844 posts in 1384 days
#1 posted 335 days ago
Nice job, would look great on anyones desk. Think I’ll have to make some of these. Thx for the post.
-- Ken, "Everyday above ground is a good day!"
Jamie Speirs
home | projects | blog
3719 posts in 1052 days
#2 posted 335 days ago
That is a wonderful piece
Nice use of negative space
It would look great on a desk
jamie
-- Who is the happiest of men? He who values the merits of others, and in their pleasure takes joy, even as though 'twere his own. --Johann Wolfgang von Goethe
MonteCristo
home | projects | blog
2065 posts in 384 days
#3 posted 335 days ago
Clever design ! Your idea of not wasting the cutout and using it for the base was a good idea too.
-- Dwight - "Free legal advice available - contact Dewey, Cheetam & Howe""
Have your say...