| Project by ssull4167 | posted 312 days ago | 1930 views | 6 times favorited | 4 comments |  |
 |
Table Saw Sled with vacuum attachment and fully enclosed blade cover. Can cut pieces up to 24 inches wide. Has an adjustable fence to get perfectly square cuts. Also has a hold down clamp and the sled has rails under the sled to keep it from tipping while cutting.
www.woodworksbysullivan.com
| Pin It |
4 comments so far
juniorjock
home | projects | blog
1774 posts in 1937 days
#1 posted 312 days ago
Looks good. Have any more photos?
Jim Jakosh
home | projects | blog
7325 posts in 1277 days
#2 posted 311 days ago
Nice sled!!!.
Lots of good ideas incorporated!
............Jim
-- Jim Jakosh.....Practical Wood Products...........Learn something new every day!!
Nate Meadows
home | projects | blog
881 posts in 378 days
#3 posted 311 days ago
I am very intrigued by your design. Does the dust cover move up and down to allow for different thicknesses of wood? Could you post a few more photos?
Very Respectfully,
Nate
-- "With a little bit of faith, and some imagination, you can build anything!" Nate
ssull4167
home | projects | blog
31 posts in 586 days
#4 posted 311 days ago
Hey guys i heard you wanted more photos. Ill get some more and try to post them tonight. Nate you were asking about the dust cover. How that works is the plastic flaps on the sides just have a little pull on them so i just pull the flap up and slide the lumber through. The totall thickness i can put through with the cover on is 3inches. Any thicker i have to remove the cover. The cover doesnt move at all because the flaps are very flexible and you just slide the lumber through and the flap will just collapse on top of the lumber. Have a great day guys. Hope it aint 100 degrees like it is here in MN . dont happen to much in this state.
Have your say...