|Project by Simon2822||posted 06-13-2012 06:17 PM||2576 views||3 times favorited||7 comments|
I decided my previous scrap made router table needed upgrading, and I had just got a new router (triton with above table bit change and height adjustment. It follows many of the other designs on here. Still a couple of things to finish. I’m not sure whether to leave the bottom right section (home to my old router) as it is in the picture or put a cupboard door on and the top right side needs something. I have more than enough bit storage on the right side. I had though drill bit storage. I also need a track for a mitre guage at some point
The table is made with 18mm ply and pine trim. Table is two pieces of ply with pine trim and a simple hole for the router. Another hole is drilled for the above table height adjustment.
-- If it's not right, it's wrong