| Project by ssull4167 | posted 359 days ago | 1925 views | 4 times favorited | 3 comments |  |
 |
I made this drill press table for my own workshop. It is made with a crank to adjust the table so I can get more control of adjusting it. Then under the table I can lock it when I have it set. I also rigged up a vacuum hook up underneath and up by the table. Under the drill press I also upt one set of drawer slides so I can slide the drill press out further if I am working with larger stock.
| Pin It |
3 comments so far
Woodbridge
home | projects | blog
1539 posts in 586 days
#1 posted 359 days ago
Nice table. I like the idea of the vacuum underneath. I never seem to be able to position a vacuum house effective when using my drill press.
-- Peter, Woodbridge, Ontario
doncutlip
home | projects | blog
2808 posts in 1724 days
#2 posted 358 days ago
Good looking setup
-- Don, Royersford, PA
helluvawreck
home | projects | blog
10413 posts in 1035 days
#3 posted 358 days ago
Very nice table. You did a nice job on this.
helluvawreck aka Charles
http://woodworkingexpo.wordpress.com
-- If a man does not keep pace with his companions, perhaps it is because he hears a different drummer. Let him step to the music which he hears, however measured or far away. Henry David Thoreau
Have your say...