LumberJocks

Air filter

  • Advertise with us
Project by sillac posted 805 days ago 2334 views 4 times favorited 7 comments Add to Favorites Watch

Just got the shop air filter done. There are three 2 inch thick MERV 11 filters and one 1 inch thick MERV 4 filter. Air is drawn through the MERV 4 filter which is in the 1st photo, then through the three MERV 11 filters in the 2nd and 3rd photos and is then blown down osb ducts to the ends of the shop, you can see one of these ducts in photo 4. Photo 5 shows about the same as photo 3 with some plywood filter holders removed. These are removable so that filters can slide out for cleaning or replacement and also so the blower/motor can also slide out if needed. The blower is attached to a piece of 3/4 ply that slides in a track so that it can be removed and is held in place with a bolt and nut on each side. Man was it a pain lifting that thing up to the ceiling. The wiring is shown in the last photo, the orange cord just plugs in and is temporary, this will be hard wired later at the junction box which is shown in photo 3 and there will be a switch with timer down below.

-- Steve in Oregon,





7 comments so far

View Joe Lyddon's profile

Joe Lyddon

7625 posts in 2656 days


#1 posted 805 days ago

Looks GREAT!

-- Have Fun! Joe Lyddon - Alta Loma, CA USA - Home: http://www.WoodworkStuff.net ... My Small Gallery: http://www.ncwoodworker.net/pp/showgallery.php?ppuser=1389&cat=500"

View Dez's profile

Dez

1113 posts in 2681 days


#2 posted 805 days ago

Looking good! No more eating sawdust for you I think!

-- Folly ever comes cloaked in opportunity!

View Ken90712's profile

Ken90712

14830 posts in 1792 days


#3 posted 805 days ago

Nice work I have a motor (fan) that I need to do this for.

-- Ken, "Everyday above ground is a good day!"

View KMT's profile

KMT

591 posts in 1266 days


#4 posted 805 days ago

Good job with a great description and pictures. You should breath easier.

-- - Martin

View Steve187's profile

Steve187

29 posts in 931 days


#5 posted 804 days ago

Great job Steve! I like the idea of using osb for duct. May have to borrow that idea. :)
Take care. Stay safe. Keep the faith.

-- Steve (North Louisiana, near Ruston)

View Martyroc's profile

Martyroc

2708 posts in 909 days


#6 posted 804 days ago

Great job, I’m working on one myself, hope it comes out as nice as yours.

-- Martin ....always count the number of fingers you have before, and after using the saw.

View canoe911's profile

canoe911

54 posts in 821 days


#7 posted 801 days ago

Nice System. Always better to have some form of filter.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase