LumberJocks

DVD Storage Rack

  • Advertise with us
Project by QuickWay posted 832 days ago 1256 views 1 time favorited 4 comments Add to Favorites Watch

Here is the material for the DVD Storage Rack. I drilled and installed dowels for the two sides (lots and lots) then glued up the sides. The shelves are cut to 2’’ width and the back 3/4 dowel in blind holes. I used pocket screws for the shelves as the easy fastener’s. Small blocks over each dowel serve as a type of book-end. The finish is yet to be determined. This should hold about 100 DVD’s. Its 46” high and 22 1/2” wide.

-- Bill Native Texan





4 comments so far

View Martyroc's profile

Martyroc

2708 posts in 929 days


#1 posted 832 days ago

This is a great design, and very nicely executed. Thanks for posting the stages of this, it always drawers a bett picture of what’s involved.

-- Martin ....always count the number of fingers you have before, and after using the saw.

View jaykaypur's profile

jaykaypur

3306 posts in 1032 days


#2 posted 832 days ago

Nice job. Clean and simple build. Looks great.

-- Use it up, Wear it out --------------- Make it do, Or do without!

View Ken90712's profile

Ken90712

14878 posts in 1812 days


#3 posted 831 days ago

Nice job!!!! looks good.

-- Ken, "Everyday above ground is a good day!"

View nomercadies's profile

nomercadies

498 posts in 962 days


#4 posted 831 days ago

I have been using the ones I find at Goodwill for fastener storage.

-- Chance Four "Not Just a Second Chance"

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase