I made a brand new front end for my Turbinaire HVLP System.
I did’nt like the looks of my new paint job on the front, so I took all the measurements.. downloaded their Logo, then drew it all out in CorelDraw
with all the holes for the controls etc. Used some nice DIAL Numbers
for the Variable Speed Control, plus lettering for the On-Off, Power Indicator,
15 Amp Fuse… Then I fed it to my Laser to cut out and engrave…
I used 1/8” Baltic Birch Ply then fit it onto the front of the machine…
Next.. a few coats of CLEAR and this is the result..
I think it really turned out good…:)
I know some of you might say “why bother”.. hmmm..
I like my equipment to look nice and because I could..LOL
5 comments so far
Roger
home | projects | blog
9192 posts in 975 days
#1 posted 381 days ago
This looks much better for sure.
-- Roger from KY. Work/Play/Travel Safe. Kentuk55@bellsouth.net
Wolffarmer
home | projects | blog
370 posts in 1409 days
#2 posted 381 days ago
Yours is better than factory, Yours goes up to 11.
Randy
-- That was not wormy wood when I started working on it.
Martyroc
home | projects | blog
2708 posts in 477 days
#3 posted 381 days ago
I always say, if you can do it better than the original,then do it. Looks good
-- Martin ....always count the number of fingers you have before, and after using the saw.
stefang
home | projects | blog
9496 posts in 1505 days
#4 posted 381 days ago
Looks great.
-- Mike, American in Norway
stefang
home | projects | blog
9496 posts in 1505 days
#5 posted 381 days ago
Looks great.
-- Mike, American in Norway
Have your say...