| Project by Andy Panko | posted 461 days ago | 834 views | 2 times favorited | 4 comments |  |
 |
Made this for my 4 year-old’s Pre-K class. It’s 3/4” clear pine with pocket screw joinery. I can’t stress enough how much I use my Kreg pocket hole jig… The only finish I put on it was a few coats of clear poly (I don’t have any pictures post-poly). I did all the design and cutting at home. I put it together during a lesson on woodworking I did for the kids in their class.
-- Andy Panko, Edison NJ, http://www.andypanko.com
| Pin It |
4 comments so far
SuburbanDon
home | projects | blog
410 posts in 1192 days
#1 posted 461 days ago
That’s a nice design. I have a pocket screw jig but don’t use it much. I’m curious how tight they stay over time. I know they can be tightened but…
-- --- It's the little tools that get you ---
Woodwrecker
home | projects | blog
3038 posts in 1773 days
#2 posted 461 days ago
I cranked out a few shop projects recently like a shelf for under my assembly table and couple of jigs, and the Kreg jig makes them in no time flat.
And if you add glue to the joint and let the screws draw it together, it is permanent ! lol
Nice job on the bench Andy.
Bet the Pre-K class loves your work too !
-- Eric
workerinwood
home | projects | blog
2540 posts in 1265 days
#3 posted 460 days ago
Very nice!! Like the design.
-- Jack, Albuquerque
Rose
home | projects | blog
17 posts in 1846 days
#4 posted 454 days ago
Thanks for sharing, it’s lovely. I also think it’s awesome about the lesson you did for the kids.
Have your say...