LumberJocks

Computer Shelf

  • Advertise with us
Project by Jeremy Greiner posted 02-01-2012 06:55 AM 1945 views 0 times favorited 2 comments Add to Favorites Watch

About 2 weeks ago I had finished my computer shelf I made out of 1/2’’ MDF and attached it to my desk (picture 3), unfortunately after an hour of using it, the computer got so hot I was concerned that it would damage the computer if left in there. I pulled the computer out and left it attached to my desk until I could figure out what I wanted to do.

Well that day was today, I unmounted it from my desk, took it out to my garage and drilled 4 holes about 1 and 1/2’’ in and then used a jig saw to cut out the center (picture 2).

The box is still sturdy enough to hold onto the computer, and allows air to flow much easier from the side vents, it’s not as pretty since it has the exposed MDF but I figured if it bothered me enough I can make a new one some day with everything I learned making this one.

It’s been set up for a few hours and there is no heat build up like there was before so I feel a lot better about it this time.

-jeremy

-- Easy to use end grain cutting board designer: http://www.1024studios.com/cuttingboard.html





2 comments so far

View a1Jim's profile

a1Jim

112103 posts in 2234 days


#1 posted 02-01-2012 07:31 AM

Good job Jeremy

-- http://artisticwoodstudio.com Custom furniture

View lawronkluve's profile

lawronkluve

2 posts in 962 days


#2 posted 02-02-2012 07:11 AM

The quality is excellent. It was hard for to assemble but in the end it was well.

west palm beach seo

-- Lawron M Kluve

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase