LumberJocks

Cypress and Walnut Burl Table

  • Advertise with us
Project by OregonBurls posted 11-01-2011 08:56 PM 1565 views 1 time favorited 3 comments Add to Favorites Watch

Just finished this this morning. Going off to a show. The slab is Cypress and the base is a Veneer core of Walnut Burl. The inlay is old growth Redwood burl . When I oiled it the cut for the glass shrunk so I will have to sand a little bit.

The ring on the bottem was CNCed so it can be a 2 piece move. I like how it turned out.

Thanks for looking
Greg

-- Greg, Southern Oregon, www.oregonburls.com What can I say but God Is Good!





3 comments so far

View grizzman's profile

grizzman

7011 posts in 1957 days


#1 posted 11-01-2011 11:05 PM

its a beauty greg, but i dont see any dutchmans on those cracks..or any epoxy in the cracks, did you decide not to use them…you might be sorry if you done at least use the dutchmans, those cracks have a good chance of getting bigger and longer…its a lot work you have there, something to think about…good luck at the show…

-- GRIZZMAN ...[''''']

View OregonBurls's profile

OregonBurls

578 posts in 1802 days


#2 posted 11-01-2011 11:21 PM

Yah, I have 3 one inch deep butterflies underneagth. it is strong.Thanks man!

-- Greg, Southern Oregon, www.oregonburls.com What can I say but God Is Good!

View sedcokid's profile

sedcokid

2675 posts in 2252 days


#3 posted 11-02-2011 03:11 AM

Very Nice Greg, you are so creative!

Thanks for sharing…... Oh, good luck at the show.

-- Chuck Emery, Michigan,

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase