Parallel corner

Interesting… Why raise the board up off of the table?

-- Chunk's Workshop pictures: http://spadfest.rcspads.com/thumbnails.php?album=135

I love the design of this project….looks like a end table…love the contemporary look …could you post a blog or something on the fabrication process please…
@ChunkyC…I believe the reason you would want to do this is to avoid the sharp bevel getting caught under the fence and thus resulting in a not perfect cut as well as a bind…

-- "thats all I have to say about that..."

Rembo, you sir must do alot of work as I see all that sawdust!Keep on cuttin’! Nice piece!

brian88,Absolutely truly.

Simple and neat idea … i always done the panels vertical

JET, has made very convenient an inclination пильного a disk in left, but nevertheless.)
This adaptation will be very useful at an inclination пильного a disk in the right.
Earlier had saw METABO

I like the design of the skids; they’re a great way to get away from the slant of he blade AND helping to insure accuracty (spend more cycles concentrating on the cut, rather than the possibility of being cut). Good job!

-- Making scrap with zen-like precision - Woodbutchery

Nice idea : )
What is your project in the last picture ?
Thank you

-- When did quiet and quite become the same word ? I'm guessing about the same time as your and you're did.

Interesting way to make a cut. Keeps the edge from sliding under the fence

-- Norman

Cool, thx

-- I am not so rich to buy cheap tools.