LumberJocks

Corner cabinet and a Bed

Project by roman posted 230 days ago 429 views 1 time favorited 15 comments Add to Favorites
View roman's profile

roman

439 posts in 375 days


Project tags/keywords

Embed This Project

LumberJocks Code

HTML Code

URL/IMG Code

Preview this project card

Corner cabinet and a Bed Corner cabinet and a Bed Corner cabinet and a Bed Click the pictures to enlarge them

The corner cabinet is made from 100% re-claimed old growth pine (aka 1820). A little different then some as it has two 4×4 posts that make the crown mould easier to look at, a little subliminal. It also has a curved counter which again adds a little distintive character. The exterior was stained black, then sanded out to give it worn/warm look and then lacquered.

the next is a bed made from oak solids and veneers. It has approximently 400 miters, all of which were done by my then, 17 year old daughter. Panels on the top of the bed are in sequence with the head board, the underside of the top beams and the outer side of the top beams. 4 rope turned posts, two right hand threads and two left hand threads are kitty corner to each other to prevent the eye from being swayed to the right, the left and or up and down. A built in blanket box finishes off the foot board. The basic frame is made with mortise and tenon complete with bolts…..........she wont squeek. There is also a recessed area at the head board for books and night lights.

the worst thing that could happen is that it wouldnt fit into the house. I measured total rise and run of the front door steps (the home looks like a midevil castle) assuming that each rise and run were the same which also gave me the angleon entry to ensure the upper section would fit….......I was wrong and one rise and one run were different from the rest. I had to give the top section a wee bit of a hair cut to get in the front door.

the top section fit into the bedroom door with no more then an 1/8” to spare. The bottom section of rails and stubby posts were assembled and then the headboard secured. Dropping the rop turning into the stumpy posts via a large dowel, then lifting the ceiling up and over the posts dropping it down onto the posts. followed by the installation of the crown moulding to the ceiling.

the room was then finished complete with a wet bar and fridge, armoir, entertainment center with pocket doors and panelling/baseboard to match the bed.

Cheers

-- http://www.furnituremann.ca/


15 comments so far

View Popintraining's profile

Popintraining

109 posts in 320 days


posted 230 days ago

Sounds like my kind of room, I’ve had some close calls getting furniture and cabinetry into houses before. I guess sometimes it’s better to be lucky then good. Great looking stuff

-- Illegitimis nil carborundum - Don't let the bastards grind you down http://woodworkingtipsfrompop.com

View Robb's profile

Robb

323 posts in 416 days


posted 230 days ago

Wow, beautiful, and great attention to detail, re: the right-hand and left-hand ropes to balance the appearance.

-- Robb

View jcees's profile

jcees

465 posts in 281 days


posted 230 days ago

Superior work, mon ami. Nice job with the fitting. It’s how we overcome the FUBARs that crop up that makes us worthy of our hire.

always,
J.C.

-- "Imagination is more important than knowledge" -- Albert Einstein

View Patrick Jaromin's profile

Patrick Jaromin

231 posts in 314 days


posted 230 days ago

Love both but especially impressed by the bed. I concur with Robb…I’m not sure that the balanced turnings would have occurred to me. I’m gonna take a wild guess that the bare ceiling light is temporary. ;)

I appreciate the pics…thanks for sharing.

-- Patrick, Chicago, IL www.TenonAndSpline.com

View Tomcat1066's profile

Tomcat1066

556 posts in 278 days


posted 230 days ago

Wow. Beautiful work.

-- "Give me your poor tools, your tired steel, your huddled masses of rust." Yep, I ripped off the Statue of Liberty. That's how I roll!

View roman's profile

roman

439 posts in 375 days


posted 230 days ago

As a younger man I worked for guy who built a kitchen for a condo, up 17 stories.

the pennisula sub assembly wouldnt fit into the elevator, nor would it wind up the 34 flights of stairs. remember that I was not the boss and for the most part I do what I am told. It was decided by the powers that be, that we would haul the big panel via a rope up the side of the building and over the balcony…...?

After much sweat the panel was pulled up and just when it was coming over the balcony, an approx., 4’ x 8’ sheet broke off, falling, falling, falling like a playing card through the air and coming down like a hatchet right into the roof of a near by home.

I am so glad that a lot of what “can go wrong” was done wrong on a another mans dime!

Thank you for the kind words

-- http://www.furnituremann.ca/

View Thor's profile

Thor

53 posts in 758 days


posted 230 days ago

The black finish on the corner cupboard is very effective. I also really admire the round edge on the front. I sure would like to see more photos of the bed. It deserves its own project heading. The built in trunk is a beautiful addition to it, but those twisted posts are gorgeous.
Christina

View CharlieM1958's profile

CharlieM1958

4170 posts in 700 days


posted 230 days ago

Great syuff!

Here at the university where I work, our carpenters were asked to build a large storage cabinet for musical instruments. Access to the room where it was going to go was not a problem, and they measured carefully to be sure it would fit through the door of the shop when they were finished. Trouble is, they never bothered to measure the door it had to pass through between leaving the shop and arriving at its final destination. Oops! Had to cut the whole thing in half.

-- Charlie M. "Woodworking - patience = firewood"

View Thos. Angle's profile

Thos. Angle

3236 posts in 444 days


posted 230 days ago

Quite the set, Roman. Great bed and nifty cabinet. Interesting how we sometimes have to work at the installation phase.

-- Thos. Angle, Owyhee Design, Oregon

View dennis mitchell's profile

dennis mitchell

2933 posts in 796 days


posted 230 days ago

I like the 4X4 post on the cabinet. They sure make it a substantial piece. The bed is awsome two. i wish you had posted them separate.

-- http://www.woodsongsfurniture.com

View Bob #2's profile

Bob #2

1944 posts in 503 days


posted 230 days ago

Nice stuff Roman.
It shows your flexibility and experience with the craft.

Your skill pretty much runs the gamut of woodworking.

Bob

-- A mind, like a home, is furnished by its owner

View Scott Bryan's profile

Scott Bryan

9039 posts in 304 days


posted 230 days ago

Roman,

This is a wonderful post. But to tell the truth I wouldn’t want to move either one, especially the bed. They both look substantial. These are very nice pieces and I think your daughter did an outstanding job, especially at her age.

Thanks for the post.

-- With God's help all things are possible- even woodworking. Woodworking is not just a hobby, it is an (expletive deleted) expensive hobby.

View roman's profile

roman

439 posts in 375 days


posted 230 days ago

thanks for the kind words

Installations…......hmmm, almost always a challenge.

the bed was a beast to lift but many hands make light work.

I have five kids. The two oldest girls (now women) are mine, and my better half has three more that are still at home, makes five. I wish I could instill in her children, what I gave my own …...?

My youngest daughter was always a quick learn and by far, the best helper I have ever had. She has surpassed any expectations I ever had of her and so far (touch wood) is excelling at life. She used to beg to quit school, come back home and work with me. Not that I dont like what I do, but there are far easier and enjoyable ways to make a living and the pay cheque is much bigger. She listened.

-- http://www.furnituremann.ca/

View Dick, & Barb Cain's profile

Dick, & Barb Cain

5047 posts in 781 days


posted 230 days ago

Some superb craftsmanship.

I’m like Dennis, I wish you would post these as separate projects.

You could post more pictures that way, & devote more info for each.

-- -** You are never to old to set another goal or to dream a new dream ****************** Dick, & Barb Cain, Hibbing, MN. http://www.woodcarvingillustrated.com/gallery/member.php?uid=3627&protype=1

View Les Hastings's profile

Les Hastings

456 posts in 255 days


posted 230 days ago

Way to go Roman, nice work! I like the bed its a killer.

-- Les, Wichita, Ks. (I'd rather be covered in saw dust!)

You must be signed in to post the comments.

Your Online Shop - Your Support Is Greatly Appreciated - Your Woodworking Showcase - 3 Ways To Help, Financially - Your Woodworking Community

Woodworking StoreApparel StoreMake a Donation
Bookmark And Share This Page
  • View all advertisers
  • Advertise with us

DISCLAIMER: All views and comments posted by members are not necessarily those of LumberJocks.com or of those working on the site.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase