|Project by billculpepper||posted 02-17-2011 04:27 AM||1520 views||0 times favorited||2 comments|
We needed a new pizza cutter. This kit was on sale today at Rockler. Has a nice threaded insert that you put in the handle and then you thread the fairly substantial cutter head on. Found it very easy to do. We eat lots of pizza, and the ability to screw off the blade section to put it in the dishwasher will come in handy
I threaded the insert onto a 5/16 bolt that I chucked in my drill press per the instructions. clamped the handle down and hand turned the DP to drive the insert into the handle while slightly raising the DP table.(I used the same DP setup to drill the hole so it went it straight).
Handle is olive wood. Finish is wipe on poly.
Anyway, I give the kit a thumbs up and will likely pick up a few more for gifts.
-- Bill Culpepper, Indiana