| Project by 007ians | posted 932 days ago | 1317 views | 1 time favorited | 3 comments |  |
 |
This is from the “I CAN DO THAT” series from Popular Woodworking.
There is an error in the plan…
If you place the bottom shelf where they tell you,
there is too much room at the top for the cantor to
be placed correctly.
After I cut the parts out, I use a router with a 1/4” round over bit
to curve the edges. I did this as an after thought, but should be
done before assembly.
I used the Kreg Jig to do the joining, but if you are good with the
router, you should try for a good tong and groove joint. I did one
like that and turned out well. I’m not good with a router & table yet.
-- The best-laid plans of mice and men often go awry. They do for me.
| Pin It |
3 comments so far
woodcrafter47
home | projects | blog
347 posts in 1274 days
#1 posted 932 days ago
Looks good to me, Thanks for posting it.
-- In His service ,Richard
yooper
home | projects | blog
171 posts in 995 days
#2 posted 931 days ago
Nice job. How did you put the last pocket screw in on each shelf – hand tighten with screw driver? The one that comes with the Kreg kit is too big.
-- Jeff, CT - better late then never
007ians
home | projects | blog
18 posts in 983 days
#3 posted 931 days ago
It was tricky, but I used the drill driver and fussed all the way. Lol
I have a speed bit extension and that helped a little.
-- The best-laid plans of mice and men often go awry. They do for me.
Have your say...