LumberJocks Woodworking Forum banner

Project Information

On my previous post, I put here on LJ on 15DEC2016, there are coasters I made of 20 pieces of firwood for each coaster. Now I wanted to speed up the proces a little and tried to make it out of one piece of wood. On last two photos are router table set ups for side and bottom grooves. Top grooves I made on tablesaw. Corners were sanded on disc sander.
They were made of 18mm beech board, dimensions in ratio as standard Euro pallets 120×80mm. Finish teak oil. They are offered as 4, 5 or 6 packs.

Gallery

Comments

· Registered
Joined
·
26 Posts
Very creative idea and great looking coasters!
 

· Registered
Joined
·
21 Posts
stari moj,opet si u biznisu…ili si opet deda mraz
ovo dobro izgleda ali jel je kaj brže je pitanje
jel kaj tokariš?
pazi prste
 

· Registered
Joined
·
949 Posts
Big time saver making them in one piece Ivan. Nicely done!
 

· Registered
Joined
·
4,567 Posts
Those are very cool, Ivan. Nice going!!

Jim
 

· Registered
Joined
·
90 Posts
Nice project Ivan. Well done!
 

· Registered
Joined
·
2,584 Posts
Super job with the coasters. I like the jig and it will speed up the process. Nice work.
 

· Registered
Joined
·
1,360 Posts
Those are really cool!!!
 

· Registered
Joined
·
4,714 Posts
Nicely done Ivan, those do look just like a large pallet!
 

· Premium Member
Joined
·
2,802 Posts
Ivan I like these. I may steal your idea and give them to friends as gifts. Actually I could see using one to lash a gift to like a delivery from a freight carrier :) Nice job!
 

· Registered
Joined
·
1,839 Posts
Cute pallets, time for a forklift. Well done Ivan.
 

· Registered
Joined
·
6,114 Posts
Sweet.
As long as no one drive away with my whiskey on that pallet. ;-)
Best thoughts,
Mads
 
Top