|Project by Thudbruiser||posted 08-26-2010 09:07 PM||1588 views||14 times favorited||11 comments|
This was made out of a whole piece of scrap hardwood for my Girlfriend. the top and bottom where cut off from a blank block of wood and then using the plans shown a small hole was drilled in the corner of each drawer. then I used a scroll saw (set at an angle of about 2degrees) very slowly to cut out each drawer. then a small section of the bottom of the drawer was cut and glued back in the bottom and because of the angle it fits snuggly.
-- Dave Nottingham England