LumberJocks

Various Cutting Boards

  • Advertise with us
Project by TheCraftyFox posted 02-10-2018 01:44 PM 294 views 1 time favorited 3 comments Add to Favorites Watch

This was round two of attempted cutting boards. My first attempt was more cutting and glueing to get the design i was looking for (similar to the last picture). I used oak,cherry, maple, walnut and purpleheart. I mainly used my super cheap benchtop tablesaw to cut to width. I would be lying if i said it didn’t scare the crap out of me with some of the cuts. I love my yellow push block though. I would never have tried this without it.

Doing a few if these, I learned a few things:
1. I need a legit tablesaw.
2. Glueing is an art. Not too little…and not too much!

Next up might have to be one of those 3D looking end grain boards!

-- Marlena, Pittsburgh





3 comments so far

View jim65's profile

jim65

990 posts in 1840 days


#1 posted 02-10-2018 08:43 PM

good looking boards! a nice table saw is good but even a good one can be scary. Always know where your fingers are and stay out of the line of fire… Thanks for sharing!

-- Jim, Marostica Italy

View John's profile

John

1080 posts in 1176 days


#2 posted 02-10-2018 11:21 PM

Nice job on the cutting boards Marlena, great choice of woods!

-- John, Sunshine Coast, BC, Canada.

View mjheck's profile

mjheck

16 posts in 1056 days


#3 posted 02-11-2018 01:40 AM

Nice looking boards. 3D cutting boards require some skilled table saw work(angle and crosscut sled cuts). Be careful. There are some good tutorials on You Tube. That’s how I learned.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com