LumberJocks

Breadboard

  • Advertise with us
Project by Jon Brandt posted 07-18-2010 05:48 AM 1393 views 0 times favorited 3 comments Add to Favorites Watch

The edges are mismatched, missing and breaking apart so the edge are cut off and install oak with tongue and groove joint. Then the customer asked me to have the oak stained match to their kitchen cabinet, the stain is made at sherwin williams and then finish over with lacquer. The cutting area are applied with butcher block oil.





3 comments so far

View patron's profile

patron

13170 posts in 2088 days


#1 posted 07-18-2010 06:13 AM

looks good there , jon .

and as you know ,

the customer is ,

always right !

well done .

-- david - only thru kindness can this world be whole . If we don't succeed we run the risk of failure. Dan Quayle

View Jonathan's profile

Jonathan

2605 posts in 1798 days


#2 posted 07-18-2010 03:18 PM

I’d like to see a picture of them with the finish done and the oil applied, do you have one?

They look good.

So these were old boards that you renewed and put new edges on?

-- Jonathan, Denver, CO "Constructive criticism is welcome and valued as it gives me new perspectives and helps me to advance as a woodworker."

View Jon Brandt's profile

Jon Brandt

16 posts in 1629 days


#3 posted 07-18-2010 08:10 PM

Ohh, I’m sorry that I don’t have picture of before and after applies the oil. Next time I should take the pictures before I start work on the project and after 100 percent completed, too. The board remain same, just light sand to remove all knife cut, only thing is new are the oak on edges.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase