Flag Displays

  • Advertise with us
Project by AlBCuttnWud posted 05-20-2017 11:03 AM 1081 views 2 times favorited 5 comments Add to Favorites Watch

I made these for going away gifts for a couple of guys I work with. The flags were flown during our last deployment. I made two coin slots in each base, one is to hold my ship’s command and the other is to hold a coin from the squadron who flew the flag during a combat mission.

You know when your table saw is dialed in when you can mock up your joints perfectly with no tape, clamps, etc. This is one of those moments when you feel all warm inside and just enjoy looking at what you did…..ha.

-- -Al, Chesapeake, VA

5 comments so far

View Gary's profile


1282 posts in 4291 days

#1 posted 05-20-2017 02:43 PM

Beautiful job.
A perfectly dialed in angled miter joint.

-- Gary, Florida

View Peteybadboy's profile


272 posts in 1916 days

#2 posted 05-20-2017 07:57 PM


-- Petey

View sheetzy's profile


160 posts in 2126 days

#3 posted 05-20-2017 11:21 PM

beautiful. how did you make the joints at the bottom. what degree. again beautiful.

-- Sheetzy

View AlBCuttnWud's profile


691 posts in 2657 days

#4 posted 05-21-2017 06:22 PM

beautiful. how did you make the joints at the bottom. what degree. again beautiful.

- sheetzy

Those are 22.5 degree cuts. I cut with the table saw using an Incra miter.

-- -Al, Chesapeake, VA

View Roger's profile


20923 posts in 2771 days

#5 posted 06-03-2017 12:29 AM

I really enjoy your finely made flag cases, sir. And, yes, it is a good feeling when things like miters go together.. lol

-- Roger from KY. Work/Play/Travel Safe. Keep your dust collector fed.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics