Projector Stand

  • Advertise with us
Project by bobkberg posted 05-11-2010 08:03 PM 2110 views 0 times favorited 2 comments Add to Favorites Watch
Projector Stand
Projector Stand No picture No picture No picture No picture No picture
Zoom Pictures

This was a commissioned piece – The projector was usually sitting on the table, but laptop computers, hands, people’s heads etc. kept getting in the way. The client was using a cardboard box for a while and got sick of that too.

Construction is 3/4” red oak veneered plywood.
Alll raw edges were veneered with oak.
The curves in the piece are based on a 1-Gallon paint can.
The platform in the middle can be adjusted and is held in place by a piece of threaded rod with screw-down handles on each side. There are extra fender washers between the platform and the sides so that nothing scrapes.

The platform is a piece of oak plywood, with a frame made from solid oak, rounded over and mitered corners.

Finish is “Golden Oak” stain, followed with sanding sealer, two coats of poly.

The fact that the phone fits below is just a lucky accident.

-- Bob - A sideline, not how I earn a living

2 comments so far

View RexMcKinnon's profile


2593 posts in 3223 days

#1 posted 05-11-2010 09:30 PM

Very practical.

-- If all you have is a hammer, everything looks like a nail!

View sras's profile


4812 posts in 3157 days

#2 posted 05-12-2010 04:18 AM

Looks like a nice design – beats a cardboard box by a long shot!

-- Steve - Impatience is Expensive

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics