LumberJocks

TV Stand

  • Advertise with us
Project by Tom8021 posted 1454 days ago 1049 views 0 times favorited 3 comments Add to Favorites Watch

A simple stand that is 13×40 x 7 walnut. I was lucky to find a 13 inch wide board for this project. I love to make something where the grain pops! The sliding dovetail was easy to do, it was getting it exactly align in the top and bottom that was tricky. Since the top overlaps and the bottom butts the legs, I had to be careful to find the centers of each. I used two different routers to cut the dovetail, one with a straight bit to clear out most of the wood and one with the dovetail bit. Of course both of the routers had different size bases so I had to make two jigs to align the cutter for each side. A lot of time setting up each jig.





3 comments so far

View Ken90712's profile

Ken90712

14500 posts in 1688 days


#1 posted 1454 days ago

Very well done, like the tapers on the ends really helps make it look special

-- Ken, "Everyday above ground is a good day!"

View workerinwood's profile

workerinwood

2673 posts in 1567 days


#2 posted 1454 days ago

Great job!!

-- Jack, Albuquerque

View Michael Murphy's profile

Michael Murphy

448 posts in 1504 days


#3 posted 1452 days ago

Nice job Tom! That is a pretty piece of Walnut. I like the tapered legs too.

-- Michael Murphy, Woodland, CA.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase