LumberJocks

Farmhouse Headboard

  • Advertise with us
Project by JerryinCreek posted 03-25-2017 02:49 PM 268 views 0 times favorited 1 comment Add to Favorites Watch

I was commissioned to make a farmhouse dining table with breadboard ends from 2×6’s a year ago. Now, the same person wanted a headboard to match it. I used the same methods to build the headboard as I used for the table.

After doing some sanding I used biscuits and glued up the long boards. I then cut a mortise in the stiles ½” wide and 2 ¼” deep on my router table. Next, I cut a tenon appropriate for the mortise with a hand held router and edge guide. I drilled holes for three dowel pegs on each side and then elongated the holes in for the top and bottom pegs to allow for wood movement. The middle third of this arrangement was glued and clamped. The top and bottom pegs only received a drop of glue near the top surface just to keep them in place.

I installed braces on the rear with elongated holes. I glued a decorative shelf to the headboard, avoiding glue on the stiles. I then glued and pin nailed quarter-round to the shelf, but not the 2×6. This should cover any gap that might form if the headboard expands in summer.

For a finish, I used a pre-stain sealer, walnut stain and several coats of polyurethane.

Thanks for looking!

-- Jerry, Johnson Creek, WI "If it was meant to be different it would be."





1 comment so far

View Don10's profile

Don10

29 posts in 1007 days


#1 posted 03-25-2017 10:20 PM

Hey Jerry,

Nice to have returning customers. Nice breadboard, rich color, nice finish. Good job!

-- Don, Silver City New Mexico, parsimony, utility and elegance - blueprint for any project.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com