LumberJocks

Just some Zero Clearance Inserts

  • Advertise with us
Project by deucefour posted 03-17-2010 05:00 AM 2002 views 2 times favorited 3 comments Add to Favorites Watch
Just some Zero Clearance Inserts
Just some Zero Clearance Inserts No picture No picture No picture No picture No picture
Zoom Pictures

I made these ZCI’s with a flush trim bit and router, however they fit a little loose in the tablesaw, I read where you should border your pattern with a few layers of blue tape before cutting, I may do this next time. until then I just wrapped the edges in some tape and it fits nice. Thanks for looking.

-- "I gotta have more cowbell"--------Bruce Dickinson





3 comments so far

View jayman7's profile

jayman7

212 posts in 2200 days


#1 posted 03-17-2010 05:16 AM

The blue tape trick works like a charm for me.

View bigike's profile

bigike

4032 posts in 1983 days


#2 posted 03-17-2010 05:19 AM

yea i used clear tape for mine but blue green black what ever works!

-- Ike, Big Daddies Woodshop, http://www.icombadaniels@yahoo.com

View WistysWoodWorkingWonders's profile

WistysWoodWorkingWonders

11908 posts in 1852 days


#3 posted 03-18-2010 05:07 AM

good job on these… I use the factory supplied insert and dial mine in with some final sanding… this way I can ensure a nice snug fit… I also use hardwood such as maple for mine and run it through the planer till it is just the right thickness… works like a charm for me…

-- New Project = New Tool... it's just the way it is, don't fight it... :)

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase