|Project by Woody1969||posted 11-27-2016 07:13 AM||349 views||3 times favorited||2 comments|
A fun little project standing approximately 120mm tall and just under 80mm across the cap and made from oak. The hole diameter is 35mm so even the largest nut will not be a problem. The body and cap were turned on the lathe but the threaded bit was made with the Beal threading system.
I would love to do thread chasing with all the possibilities it would open up but my lathe won’t go slow enough, good excuse for a new lathe if I can get enough cash :)
-- John, UK, https://www.whitlockwoodendesigns.com/