LumberJocks

More Cuttingboards

  • Advertise with us
Project by McFly posted 07-30-2016 07:52 PM 349 views 0 times favorited 2 comments Add to Favorites Watch

Carved out a little shop time and cranked out another 5 boards. Started using different router bits to add a little something extra.
Mostly maple with walnut accents, there was one with some Jatoba ends and one with a center stripe of mahogany.





2 comments so far

View Axle505's profile

Axle505

100 posts in 233 days


#1 posted 07-30-2016 08:58 PM

I like the boards! Did you use biscuits for these or just clamps?

View McFly's profile

McFly

173 posts in 424 days


#2 posted 07-30-2016 11:23 PM

Nooe, no biscuits here, but I could add them down the line. I have access to a festool domino tool.

These were jointed, planed, ripped on a dedicated straightline saw and glued up on a rotisserie clamp rack, sanded 60 & 80 in a 54" drum sander, edges finished with my router and then through the drum sander again 100 & 120 grit. After that, I mist em with water, raise the grain and run through 80 to 220 with wet sanding from a palm sander for the finish @ 320grit. Mineral oil & caranuba wax to finish. Might start buffing them on the next run.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com