LumberJocks

PLYWOOD DRINK MATS/ COASTERS !

  • Advertise with us
Project by Tom Howbridge posted 02-02-2016 09:29 PM 745 views 0 times favorited 2 comments Add to Favorites Watch

Please check out the video here

I ripped my 18 mm thick plywood down to 100 mm wide then set up a stop and set my fence to cut 12.5 mm strips referencing off of the stop. I then spread glue on the pieces and glue them together with the ply laminations facing outwards. I then proceeded to do a lot of sanding to get them flat, I previously tried some varnish I had but it looked terrible so I used some boiled linseed oil, it works fine although at some point i want to invest in some tung oil. I might cover another technique of making these in a future video.

I would highly recommend you use the highest quality you can get as it will make your life easier as it will have no voids, I used a scrap
piece I had.

After sanding the final measurements are 10×90 x 100 mm

Thanks for watching if you enjoyed this video please consider sharing this video and check out my channel and social media.

-- Check out my weekly videos at http://www.youtube.com/TomHowbridge





2 comments so far

View ChrisK's profile

ChrisK

1809 posts in 2546 days


#1 posted 02-03-2016 12:48 PM

Neat look.

-- Chris K

View Tom Howbridge's profile

Tom Howbridge

60 posts in 847 days


#2 posted 02-04-2016 12:55 PM



Neat look.

- ChrisK

Thanks ChrisK

-- Check out my weekly videos at http://www.youtube.com/TomHowbridge

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com