| Project by RobH | posted 64 days ago | 423 views | 2 times favorited | 5 comments |  |
 |
Well, the first part of the office furniture is finally done. I am hoping to get the computer switched over to the new desk tomorrow night. It may take a little longer though. Just in case you have not been following the blog, this table is made mainly from two 16’ 2×16s that I found at home depot. The finish consists of two coats of Zinsser SealCoat followed by two coats of Minwax Polycrylic. The finish was sanded with 220 between coats.
Thanks for looking.
-- -- Rob Hix, King George, VA
5 comments so far
Napaman
home | projects | blog
3486 posts in 971 days
posted 64 days ago
turned out great….is it set up in the new office yet???
-- Matt, Napa, CA...fun is beautiful...just trying to have some fun...
NorthGaMan
home | projects | blog
47 posts in 256 days
posted 64 days ago
2×16’s ?? Very nice table and I like the pegs on the breadboard end.
Joanne
home | projects | blog
82 posts in 91 days
posted 63 days ago
Beautiful, I never thought of using 2X’s but the table looks great.
-- Joanne, New York, www.creationhollow.com
Ed Elizondo
home | projects | blog
80 posts in 417 days
posted 36 days ago
The table came out really good. Good design.
-- Ed E. " Taking one board at a time "
a1Jim
home | projects | blog
16770 posts in 471 days
posted 36 days ago
A very nice table with clean cool lines, well done.
-- Jim from Heirloom Woodshop Southern Oregon