|Project by Tom Howbridge||posted 12-22-2015 02:36 PM||1165 views||0 times favorited||5 comments|
This was a fun project and very quick to make.
I first cut a bit of beech approx 40×40 then I drilled a slightly offset hole to accept a coach bolt I then tightened it down with a nut and washer I then drove in two washer head screws, I used some sheet metal screws as they had a flat head for grip on the bottle cap but it took a while to drive them in because of the metal predicted profile on the end.
In the video to test it out I found I needed it on speed one on the highest torque and by just pressing the trigger slowly with better practise this could be done a lot quicker by and would e really impressive !
Measurements are not critical so have a play around and see what works best ! if you do make it then please send me an email or a message on YouTube I would love to see it !
Watch the video here https://www.youtube.com/watch?v=3fEXC8rKJAA
-- Check out my weekly videos at http://www.youtube.com/TomHowbridge