Assembly Table with T-Track top

  • Advertise with us
Project by Peteyb posted 11-15-2015 06:22 PM 3587 views 17 times favorited 5 comments Add to Favorites Watch

Here is my take on Wood Whispers Assembly table. I made it so that it is the about the same height as my table saw so that I could use it over there also if needed. I also wanted a dedicated space to put things together instead of using my outfeed table. This way I can continue to work on a project and not have to move things around and still use the table saw.

I constructed it out of plywood, MDF, Maple and Walnut. I used the Maple to reinforce the base with wheels that it sits on as I have done with a lot of my bases that I have constructed. I made the top of torsion box top with MDF and then put white Formica on the top. I like this as it brightens the shop, easy to clean, and can write on it. I then used walnut to around then top and all doors.

You can also see that I put my small compressor in there so that it is easy at hand where I will use it the most. On the two ends you can see how I have stored my hose, clamps and a few other things that need easy access to.

I like having the t-track in on the top as there are many different hold downs that I can use and ways to clamp things up when needed.

5 comments so far

View htl's profile


2532 posts in 767 days

#1 posted 11-15-2015 07:45 PM

Nice table.
You can get your projects done on that for sure.

-- There's a hundred ways to do anything, alot depends on the tools at hand.

View helluvawreck's profile


25375 posts in 2474 days

#2 posted 11-15-2015 08:09 PM

This will be a very nice fixture in your shop and it will have several uses that come to mind. Especially if the T-tracks are accurately positioned to each other with 90 deg. angles that are close to accurate. Congratulations.

helluvawreck aka Charles

-- If a man does not keep pace with his companions, perhaps it is because he hears a different drummer. Let him step to the music which he hears, however measured or far away. Henry David Thoreau

View Peteyb's profile


131 posts in 2163 days

#3 posted 11-16-2015 02:53 AM

Charles it was a bit of work but made sure to keep all meeting points at 90 degree angles.

View HighPointWW's profile


49 posts in 1103 days

#4 posted 11-16-2015 10:44 AM

Well done! Nice attention to detail and organization.

View Don K's profile

Don K

27 posts in 727 days

#5 posted 09-12-2016 08:05 PM

Nice table. Is the T-Track from Rockler? If so, do the Kreg auto-clamps ( fit?


-- v/r, Don -- Saw dust is 'MAN GLITTER' --

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics