|Project by Mark Duncan||posted 07-30-2009 11:26 PM||2827 views||0 times favorited||1 comment|
I found an awesome design of a tractor one day while i was searching for stuff on my computer one day and decided to print it out. While i was out in the shop one day i found a board of oak and it was the right size so I taped the print onto the board and got a razor knife and cut out all the details and then burned them to “bring them to life” if that sounds good. So after I got done with the design, I put a round over bit in the router/shaper and did the detail around the edge. I then stained it with Minwax American Oak. After one coat of that, there were 2 coats of wipe on polyurethane.
-- Mark Duncan, Central California