|Project by degoose||posted 06-24-2009 10:10 AM||1933 views||4 times favorited||18 comments|
All the cuts for this board are 15 degrees off square. i.e 75 degree tilt to the table saw to cut the strips then the mitre express is set to 15 degrees and the table saw blade is left at 75 degree bevel so all cut are 15 degree off. Then roll up on the cut side and glue.
Every face of every piece is off square by 15 degrees.
Look at the sides.. all angled on all sides and the diamonds on the face are all 75/105 and even they are off square to the sides. The only right angles are the sides.. even the corners are … rounded lol. ok still the same timbers.. PH SA TB and NGR.. oil finish.
Size .. .. 14” not square. lol
-- Drink twice... and don't bother to cut... @ lazylarrywoodworks.com.au For lovers of all things timber...