|Project by cabinetmaster||posted 05-26-2009 01:53 AM||2429 views||4 times favorited||11 comments|
This range hood is made from Maple lumber and Birch plywood. It is approximately 60” wide X 24” deep X 66” tall. It has 2 pullout spice racks on each side. All of the onlays, corbels, and sea shell were carved by a carver in our shop. The hood liner for this hood is a ventless hood. Therefore I had to cut vents into the top part of the mantel. If you look closely in the second picture you can see these vents. The applied molding was made in our shop.
The hood was painted and glazed and then a lacquer finish over that. The doors were not dry when this hood was delivered so I did not get a picture after they were installed on site.
I’d appreciate any and all critiques good or bad.
-- Jerry--A man can never have enough tools or clamps