LumberJocks

Mesquite end grain counter top chop block.

  • Advertise with us
Project by BlueStingrayBoots posted 08-04-2015 06:40 PM 951 views 0 times favorited 3 comments Add to Favorites Watch

Mesquite end grain counter top chop block.

35.25” x 17.25” x 2.5”

I went through 2 and a half huge slabs to finish up with this piece. Tight bond II glue, mineral oil soaking then a mix of beeswax and oil to finish the seal. My drum sander robots helps out plenty!





3 comments so far

View John Stegall's profile

John Stegall

478 posts in 2978 days


#1 posted 08-04-2015 09:14 PM

Good looking use of mesquite. One of these days I am going to come up with a way to safely allow me to use it again. Even cutting it by hand sets off my allergies.
Question, do you find TB II holds up in a kitchen environment? I went through a bottle of 3 and 2 is easier to use for me at least.

-- jstegall

View BlueStingrayBoots's profile

BlueStingrayBoots

770 posts in 3464 days


#2 posted 08-05-2015 06:37 AM

Thanks John. TBII has worked so far. I haven’t used the other two.

View Ken90712's profile

Ken90712

16955 posts in 2651 days


#3 posted 08-05-2015 08:29 AM

I use III only on cutting boards being its water proof vrs II being water resistant. I theory your not suppose to get end grain boards real wet so II should work.
Nice board and flow, boy thats alot of feet on the bottom.

-- Ken, "Everyday above ground is a good day!"

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com