|Project by ppworkshop||posted 07-20-2015 08:21 PM||1077 views||0 times favorited||2 comments|
Pretty simple project. I used an old candle mold to hold all my drills. I attached the mold to a pine board with screws/glue. Then attached the drill holder to the side of the cabinet via the holes in the corner brackets using screws and washers. Then I drilled a hole in the bottom of each mold, so the drills will still fit when there is a bit attached. The drills are within easy reach, out of the way (behind the drill press).
-- Patrick Parson Workshop