|Project by whope||posted 06-08-2015 04:53 PM||1314 views||4 times favorited||5 comments|
I have a table saw cart I’m working on. Of course, since it has the table saw installed, finishing it is a low priority. This is a sub-assembly that I finally decided to make. Holds 10 blades and a deeper ‘drawer’ for measuring tools.
This is made from scraps. Except the 1/2” dowel. I didn’t have one of those laying around. The 5/8” dowel was too tight and I didn’t want to fight putting the blade on the dowel. The dowel was a really snug fit (hammer tight), so no glue on it or the riser piece. If/when it loosens up, I’ll glue it then.
I’ll be using the top to store the miter gauge when it’s off the saw.
Thanks for looking.
June 24th Note: Apparently the Table Saw Cabinet from the June/July 2012 issue of Woodcraft magazine wormed it’s way into my brain. I ran across my issue over the weekend.
September 7th Note: Decided that I needed a way to keep track of which blade is where. Not really a big deal, but I also needed drawer pulls. Decided on 1 1/4” drywall screws and black chalk paint.
-- Measure it with a micrometer, mark it with chalk, cut it with an axe.