| Project by azwoodman | posted 241 days ago | 383 views | 0 times favorited | 2 comments | ![]() |
![]() |
This project is also hanging on the wall in my friend’s home office. I built it around the same time as the little table project and the single album display frame (that i posted about 5 min ago…). Forty five degree miter joints at the corners. Then simple butt joints for the inside frame. I cut the continuous kerf that is around the edge of the frame while each piece was separate and then joined them together. After it was assembled, i ran it over the table saw to get the through kerfs and create the chris-cross pattern at the corners. I cut one side of the frame thinner that the other three and cut rabbets around the inside to accommodate the album on each section. The back is just some cheap, thin, hard board that i bought at HD. I drilled a couple holes in the back to hang the piece on the wall. It can be hung horizontally (as shown) or vertically.
-- -Spencer, Gilbert Az (http://www.azwoodshop.com)
































2 comments so far
a1Jim
home | projects | blog
16776 posts in 472 days
posted 240 days ago
Nice Frame Spencer. Ingenuous design.
Jim
-- Jim from Heirloom Woodshop Southern Oregon
john
home | projects | blog
1190 posts in 1276 days
posted 104 days ago
Great job!! I like it a lot !!
-- John in Belgrave ,(Slideshow http://cid-69bce320c6d8b119.spaces.live.com/ (Website) http://www.extremebirdhouse.com