Single Album Display Frame

This project is hanging on the wall in my friend’s home office. I built it around the same time as the little table project (that i posted about 5 min ago…). Forty five degree miter joints at the corners. I cut the continuous kerf that is around the edge of the frame while each piece was separate and then joined them together. After it was assembled, i ran it over the table saw to get the through kerfs and create the chris-cross pattern at the corners. I cut one side of the frame thinner that the other three and cut rabbets around the inside to accommodate the album. The back is just some cheap, thin, hard board that i bought at HD.

-- -Spencer, Gilbert Az (http://www.azwoodshop.com)